Replace The Cp Pad Set; Cleaning Or Replace The Pinch Roller - MIMAKI JV300-130 A Operation Manual

Chapter 4 Maintenance

Replace the CP pad set

Replace CP pad set (SPA-0257) when it is dirty.
Push up the tabs (2places) of CP pad Assy.
1
CP pad Assy
Remove the CP pad Assy.
2
Attach a new CP pad Assy.
3
• After inserting the tabs of CP pad Assy to the slit
of C slider, fit the whole.
Tabs
C Slider
4-4
CP pad Assy
Press to lock the tab

Cleaning or replace the pinch roller

Cleaning the pinch roller (SPA-0247) when it is dirty.
Also replace the pinch roller when it is worn or dirty.
Raise the clamp lever to keep the pinch
1
roller lifted.
Remove the O-ring retaining the pinch
2
roller.
• Be careful not to drop the parts in the gap of the
device as they are small.
O-ring
Remove the pinch roller.
3
• Be careful not to drop the parts in the gap of the
device as they are small.
Clean the O-ring and pinch roller.
4
• Wipe off the ink sticking to the O-ring and pinci
roller with a clean stick dipped in cleaning solution
for maintenance. Wipe off so that cleaning
solution for maintenance will not remain.
• Attach a new pinch roller, and reattach a new O-
ring to their original position when dirt does not fall
even if it cleans it.
Pinch roller