Test Data Register (Dr); Boundary Scan Registers; Figure 10.3 Diagram Of Observe-Only Input Cell - Renesas IDT 89HPES4T4 User Manual

IDT JTAG Boundary Scan
Notes
PES4T4 User Manual

Test Data Register (DR)

The Test Data register contains the following:
Bypass register

Boundary Scan registers

Device ID register
These registers are connected in parallel between a common serial input and a common serial data
output and are described in the following sections. For more detailed descriptions, refer to IEEE Standard
Test Access Port (IEEE Std. 1149.1).
Boundary Scan Registers
This boundary scan chain is connected between JTAG_TDI and JTAG_TDO when EXTEST or
SAMPLE/PRELOAD instructions are selected. Once EXTEST is selected and the TAP controller passes
through the UPDATE-IR state, whatever value that is currently held in the boundary scan register's output
latches is immediately transferred to the corresponding outputs or output enables.
Therefore, the SAMPLE/PRELOAD instruction must first be used to load suitable values into the
boundary scan cells, so that inappropriate values are not driven out onto the system pins. All of the
boundary scan cells feature a negative edge latch, which guarantees that clock skew cannot cause incor-
rect data to be latched into a cell. The input cells are sample-only cells. The simplified logic configuration is
shown in Figure 10.3.
Input
Pin
From previous cell
shift_dr
clock_dr

Figure 10.3 Diagram of Observe-only Input Cell

The simplified logic configuration of the output cells is shown in Figure 10.4.
D
10 - 4
To core logic
To next cell
Q
February 1, 2011