Security Info; System Settings - Teltonika FMB920 User Manual

5.3

Security info

In security section user can see SIM card and configurator keyword security information.
 User can see SIM state and SIM current status. If used SIM card with PIN code user
can enter it here. How much attempts left to enter pin code is showed to.
 For configuration security keyword can be set to configurator. Keyword can be
saved in configuration file (.cfg), so there is no nead to connect the device to the
configurator to configure keyword. Min keyword length is 4 symbols and max
length is 10 symbols. Only uppercase and lowercase letters and numbers are
supported. Keyword can be configured to .config configuration file when device is
not connected to device.
5.4

System settings

System settings have 9 configurable parameters:
 Sleep settings, where user can choose sleep mode;
 Ignition source, where user can choose between power voltage, digital input 1,
accelerometer and engine RPM as ignition sources. More than one ignition source
can be selected at the same moment. User can select movement start and
movement stop delay time (in seconds): those parameters are used when ignition
source is accelerometer. Into ignition status take the following functionalities:
power manager, eco driving, excessive idling, fuel consumption, over speeding,
towing and trip functionalities.
 Object Motion Detection Settings, where user can configure 4 ways how FMB920
will detect stopped movement, and change its working mode (for working modes,
read section 5.9). Other functionalities that depend from movement source: power
manager, fuel consumption and trip.
 Static navigation settings, where user can turn static navigation on or off.
Additional, user can chose from what source (movement or ignition) static
navigation can be deactivated/activated;
 Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
 GNSS source Settings, where user can choose satellite system.
 LED indication, where user can turn on or off indication leds.
 Battery charge mode, where user can choose when battery will be charged: on
need (battery will be charged anytime when it need to be charged) and after
ignition ON (battery will be charged only when ignition is on).
 Time synchronization settings, where user can choose from what source (or
sources) FMB920 time will be synchronized. User has choice to use only one
synchronization source by GNSS. When selected synchronization from NTP, time
will be synchronized from NTP server and from GNSS. When selected
synchronization from NITZ, time will be synchronized from GSM operator and GNSS.
When selected synchronization from NITZ+NTP, time will be synchronized from all
three sources (if it is necessary). Every time GNSS fix will be acquired time will be
synchronizes (if needed). User can select from what NTP server (possible to
configure two servers) time will be synchronized and what time period (in hours) is
used to resynchronize time.
30