Preparing The Control Unit - Siemens SIDOOR ATD4 W Series System Manual

Table 10-1
Step
1
2
3
4
5
6
7
8
10.2

Preparing the control unit

Preparing the control unit for connection and installation
1. Nudge the door into the CLOSED position.
2. Open the housing cover.
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA
Procedure for commissioning a door drive
Procedure
Preparing the control unit
Connecting a geared motor to the control unit
Connect relay outputs of the control unit (optional, only for
control units with relay outputs)
Connecting the control unit to the fieldbus (optional, only
for control units with the corresponding module):
• PROFIBUS
• PROFINET
Connecting the power supply to the network and executing
a learn run
Connecting digital input signals
Commissioning the control unit on the fieldbus (optional,
only for control units with corresponding module)
Final settings and checks
Connecting and commissioning
10.2 Preparing the control unit
Reference
Preparing the control unit
(Page 295) section
Connecting a geared motor to
the control unit (Page 296) sec‐
tion
Relay module (Page 136) section
• PROFIBUS module (Page 139)
section
• PROFINET (Page 149) section
Connecting the power supply to
the network and executing a
learn run (Page 298) section
Digital input signals (Page 299)
section
Commissioning the control unit
on the fieldbus (Page 299) sec‐
tion
Final settings and checks
(Page 301) section
295