Maintenance - Siemens SIDOOR ATD4 W Series System Manual

Alarms
Remedying alarms
Display
4
5
P / _
a
y
1)
1) SIDOOR ATD420W / ATD430W
11.3

Maintenance

The SIDOOR system should be included in the maintenance schedule for the door system as a
whole, and inspected in the course of the maintenance cycles stated in the schedule.
Note
Recommended maintenance cycles provided in the table below may vary according to the
ambient conditions and the stress on the system.
Object
DC geared motor
SIDOOR control unit
Visual inspection of the control unit, the fastening of the mo‐
tor mount, the pulley and the mounting brackets for dirt,
damage and proper installation. In addition, an inspection of
the door function is recommended for running or grinding
noises.
The belt tension should be checked
With mechanical changes of the system, for example, due to maintenance or wear (friction, dirt, engine replacement, belt
replacement or modification of the general door mechanism), an inspection is recommended for the commissioning param‐
eters relating to the safety-related settings for forces and energies/velocities.
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA
Solution
If possible, the system's drive cycle time should be reduced. Check whether the door oscil‐
lates in the end positions. Then possibly increase the continuous pressure torque or leave
the door command in the end positions.
The new motor type must undergo a learn run. See section Learn run (Page 46).
It is imperative that a new learn run be performed during ongoing operation.
As of V1.12:
All inputs of the triggering discrepancy analysis block must be reset/set (Page (Page 99)).
Communication with the master system is interrupted. The alarm is cleared as soon as
communication is restored.
Recommended maintenance interval
Maintenance-free
Maintenance-free
1 year
1 year
Diagnostic and maintenance
11.3 Maintenance
305