Connecting Digital Inputs; Commissioning The Control Unit On The Fieldbus - Siemens SIDOOR ATD4 W Series System Manual

6. The display on the control unit is as follows:
– The 7-segment display (H401) shows "H.". The decimal point in the 7-segment display
– The LCD display (H1) shows "'H': learn run activated".
7. The door can now be opened with the OPEN button (S402).
– The 7-segment display (H401) shows "o" while the door is opening.
8. Switch off the control unit by pulling out the power plug or the connector X3.
10.5

Connecting digital inputs

Connecting digital inputs
Connecting digital input signals
1. Insert the terminal connectors for the digital control inputs in X6, X5 and X4. See
section Digital input signals (Page 132) for more on this.
Note
Risk of injury through moving mechanical parts.
The controller will be operative after the next switch-on. If a control signal is present, the
door will move in the set direction.
2. Select the FBLOCK configuration according to the wiring of the input signals via the service
menu. See section Digital input signals (Page 132) for more on this.
10.6

Commissioning the control unit on the fieldbus

Introduction
If your controller is equipped with a PROFIBUS or PROFINET module, you can operate the
controller at the respective fieldbus with a higher-level controller.
The following procedure describes how to commission a SIDOOR control unit on the respective
fieldbus.
ATD4xxW for industrial applications
System Manual, 06/2022, A5E51901827B AA
(H401) flashes during the save process.
The 7-segment display (H401) shows "u" when saving has finished. If a light barrier /
pressure sensitive edge (SIDOOR ATD4xxW) is used, the 7-segment display (H401) shows
"O." because X6 is not connected yet.
For the M3, M4 and M5 motors, the determined door width is shown on the LCD for the
first commissioning or motor adaptation.
Connecting and commissioning
10.6 Commissioning the control unit on the fieldbus
299