Table of Contents
Advertisement
8.
Set the host function mode for the controller using the target ID numbers set in
step 7. Use the following command:
NOTE: The default host function mode defaults to Host Mode A. The
HOST_FUNCTION switch changes the host function mode to a different mode.
SET THIS_CONTROLLER HOST_FUNCTION= ( ID, MODE )
or
SET OTHER_CONTROLLER HOST_FUNCTION= ( ID, MODE )
To change the host function mode, see "SET controller," page 5–91 for information
on the HOST_FUNCTION switch.
9.
Restart the controllers using the following command:
NOTE: After restarting the other controller, the EMU alarm will sound. To stop it,
restart this controller.
RESTART OTHER_CONTROLLER
RESTART THIS_CONTROLLER
See "RESTART controller" in Chapter 5, "CLI Commands."
10. Set the time on the controller, which provides a baseline for replacing the
external battery, using the following command:
SET THIS_CONTROLLER TIME=DD-MMM-YYYY:HH:MM:SS
NOTE: All values are numbers, except for MMM, which uses the first three
letters of the month. When setting hours, minutes, and seconds—HH, MM,
and SS—you must use 24-hour time.
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
2–19
Advertisement
Chapters
Table of Contents
