Clear_Errors Device-Name Unknown - Compaq StorageWorks HSZ80 Configuration And Cli Reference Manual

5–38 CLI Commands

CLEAR_ERRORS device-name UNKNOWN

If a device failure causes the controller to label the device as unknown, the controller
does not check the device again to see if it has been repaired or if the error condition
has been corrected. You must enter this command so the controller can recognize the
device after the cause of the error has been corrected.
Use this command to force the controller to recognize a failed device, regardless of
the controller's prior evaluation of the device's condition.
Syntax
CLEAR_ERRORS device-name UNKNOWN
Spell out UNKNOWN when using this command.
Parameters
device-name
Identifies the device with the unknown error.
Example
This example shows how to force the controller to recognize a previously unknown
device named DISK30000:
CLEAR_ERRORS DISK30000 UNKNOWN