Table of Contents
Advertisement
5–102
CLI Commands
SET device-name
Changes the transportable characteristics and the maximum data transfer rate between
the controller and the specified device.
Syntax
SET device-name
Parameter
device-name
Specifies the name of the device to change. This can be a previously named device,
disk, passthrough device, or container.
Switches
LOCAL (Default)
REMOTE
Specifies the disk characteristics in a mirrorset, either local or remote.
Disks set to REMOTE can only be added to mirrorsets and JBOD (that is, not
RAID5 raidsets).
Disks set to REMOTE can only be added to mirrorsets that are set to
DT_SUPPORT.
Disks set to LOCAL can be added to mirrorsets that are set to either
NODT_SUPPORT or DT_SUPPORT.
Disks set to REMOTE that are part of a mirrorset will not be the read source.
Setting the switch to REMOTE forces a disk to be NOTRANSPORTABLE.
Advertisement
Chapters
Table of Contents
