Table of Contents
Advertisement
5–130
CLI Commands
ENABLE_ACCESS_PATH=
DISABLE_ACCESS_PATH=
THIS_PORT_1_ENABLE_ACCESS_PATH=
THIS_PORT_1_DISABLE_ACCESS_PATH=
THIS_PORT_2_ENABLE_ACCESS_PATH=
THIS_PORT_2_DISABLE_ACCESS_PATH=
OTHER_PORT_1_ENABLE_ACCESS_PATH=
OTHER_PORT_1_DISABLE_ACCESS_PATH=
OTHER_PORT_2_ENABLE_ACCESS_PATH=
OTHER_PORT_2_DISABLE_ACCESS_PATH=
Specifies the access path. It can be a single specific host ID, multiple host IDs, or all
host IDs (ALL). If you have multiple hosts on the same bus, you can use this switch to
restrict hosts from accessing certain units. This switch limits visibility of specific
units from certain hosts. For example, if two hosts are on the same bus, you can
restrict each host to access only specific units.
ENABLE_ACCESS_PATH and DISABLE_ACCESS_PATH switches are available
only when in transparent mode; the other switches are available only when in multiple
bus failover mode.
If you enable another host ID, previously enabled hosts are not disabled. The new ID
are added. If you wish to enable only certain IDs, disable all access paths
(DISABLE_ACCESS_PATH=ALL or
THIS(OTHER)_PORT_1(2)_DISABLE_ACCESS_PATH=ALL), then enable the
desired IDs. The system will display the following message (transparent failover
mode, typical):
Warning 1000: Access IDs in addition to the one(s) specified are still
enabled. If you wish to enable ONLY the id(s) listed, disable all
access paths (DISABLE_ACCESS_PATH=ALL), then enable the ones
previously listed.
Advertisement
Chapters
Table of Contents
