Table of Contents
Advertisement
6.
Set the host function mode for the controller using the target ID numbers set in
step 5. Use the following command:
NOTE: The default host function mode defaults to Host Mode A. The
HOST_FUNCTION switch changes the host function mode to a different mode.
SET THIS_CONTROLLER HOST_FUNCTION= ( ID, MODE )
To change the host function mode, see "SET controller," page 5–91 for information
on the HOST_FUNCTION switch.
7.
Restart the controller using the following command:
RESTART THIS_CONTROLLER
See "RESTART controller" in Chapter 5, "CLI Commands."
8.
Set the time on the controller, which provides a baseline for replacing the
external battery, using the following command:
SET THIS_CONTROLLER TIME=DD-MMM-YYYY:HH:MM:SS
NOTE: All values are numbers, except for MMM, which uses the first three
letters of the month. When setting hours, minutes, and seconds—HH, MM,
and SS—you must use 24-hour time.
9.
Set up the battery discharge timer:
a.
Start Frutil using the following command:
RUN FRUTIL
Frutil displays the following:
Do you intend to replace this controller's cache battery? Y/N
b.
Enter Y(es).
Frutil displays a three-step procedure and prompts you to press return.
c.
Press return.
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
2–7
Advertisement
Chapters
Table of Contents
