Compaq StorageWorks HSZ80 Configuration And Cli Reference Manual page 184

4–36 Configuring Storagesets
Use the following procedure to move a storageset while maintaining the data it
contains:
1. Show the details for the storageset you want to move. Use the following syntax:
SHOW storageset-name
2. Physically label each member with its name and PTL location.
If you do not have a storageset map for your subsystem, you can enter the LOCATE
command for each member to find its PTL location. Use the following syntax:
LOCATE
To cancel the locate command, use the following syntax:
LOCATE CANCEL
3. Delete the unit-number shown in the "Used by" column of the SHOW storageset-
name command. Use the following syntax:
DELETE
4. Delete the storageset shown in the "Name" column of the SHOW storageset-
name command. Use the following syntax:
DELETE
5. Delete each disk drive—one at a time—that the storageset contained. Use the
following syntax:
DELETE
DELETE
DELETE
6. Remove the disk drives and move them to their new PTL locations.
7. Add each disk drive to the controller's list of valid devices. Use the following
syntax:
ADD DISK
ADD DISK
ADD DISK
disk-name
unit-number
storageset-name
disk-name
disk-name
disk-name
disk-name PTL-location
disk-name PTL-location
disk-name PTL-location