Configuring A Stripeset - Compaq StorageWorks HSZ80 Configuration And Cli Reference Manual

Configuring a Stripeset

See "Using Striped Mirrorsets for Highest Performance and Availability," page 3–18
for information about creating a profile and understanding the switches you can set
for this kind of storage unit.
To configure a stripeset:
1. Create the stripeset by adding its name to the controller's list of storagesets and
specifying the disk drives it contains. Use the following syntax:
ADD STRIPESET
2. Initialize the stripeset. If you want to set any Initialize switches, you must do so
in this step. Use the following syntax:
INITIALIZE
See "INITIALIZE," page 5–62, for valid switches and values.
3. Present the stripeset to the host by giving it a unit number the host can recognize.
Optionally, you can append Unit switch values. If you do not specify switch
values, default values are applied.
ADD UNIT
See "ADD UNIT," page 5–27, for valid switches and values.
4. Verify the stripeset configuration and switches. Use the following syntax:
stripeset-name
SHOW
5. Verify the unit configuration and switches. Use the following syntax:
SHOW unit-number
stripeset-name DISK
stripeset-name switch
unit-number stripeset-name switch
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
nnnn DISK nnnn
4–3