Table of Contents
Advertisement
3.
Present the mirrorset to the host by giving it a unit number the host can recognize.
Optionally, you can append Unit switch values. If you do not specify switch
values, default values are applied. Use the following syntax:
unit-number mirrorset-name switch
ADD UNIT
See "ADD UNIT," page 5–27, for valid switches and values.
4.
Verify the mirrorset configuration and switches. Use the following syntax:
mirrorset-name
SHOW
5.
Verify the unit configuration and switches. Use the following syntax:
SHOW
unit-number
Example
The following example shows the commands you would use to create Mirr1, a two-
member stripeset:
ADD MIRRORSET Mirr1 DISK10000 DISK20000
INITIALIZE MIRR1
ADD UNIT D110 MIRR1
SHOW MIRR1
SHOW D110
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
4–5
Advertisement
Chapters
Table of Contents
