Entering Cli Commands - Compaq StorageWorks HSZ80 Configuration And Cli Reference Manual

Device Commands—Create and configure containers made from physical
devices attached to the controller.
Storageset Commands—Create and configure complex containers made from
groups of device containers. There are four basic types of storagesets: stripesets,
RAIDsets, striped-mirrorsets, and mirrorsets. Storageset commands group device
containers together and allow them to be handled as single units.
Logical Unit Commands—Create and optimize access to logical units made from
containers.
Failover Commands—Configure the controllers to operate in transparent or
multiple bus failover while also providing support for dual-redundant
configurations.
Diagnostic and Utility Commands—Perform general controller support functions
Getting Help
Help for using the CLI is at your fingertips. For an overview of the CLI help system,
enter help at the prompt. For help on a specific command or to determine what
switches are available with a command, enter as much of the command as you know
followed by a space and a question mark. For example, to get information on the
switches used with the SET THIS_CONTROLLER command, enter:
SET THIS_CONTROLLER ?
See the HELP command on 5–60 for further information.

Entering CLI Commands

Use the following tips and techniques when entering CLI commands:
Commands are not case sensitive.
For most commands, you only need to enter enough of the command to make the
command unique. For example, SHO is the same as entering SHOW.
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
5–3