Compaq StorageWorks HSZ80 Configuration And Cli Reference Manual page 203

scsi-port-target-lun
Indicates the SCSI device PTL address. Place one space between the port number,
target number, and the two-digit LUN number when entering the PTL dress. See the
"Device PTL Addressing Convention within the Controller," page 3–36, for an
explanation of the PTL addressing naming format.
NOTE: See the HSZ80 Array Controller ACS Version 8.3 Release Notes to
determine whether the disk drive you are planning to use is compatible with the
controller.
TRANSFER_RATE_REQUESTED=ASYNCHRONOUS
TRANSFER_RATE_REQUESTED=20MHZ (Default)
TRANSFER_RATE_REQUESTED=10MHZ
TRANSFER_RATE_REQUESTED=5MHZ
Specifies the maximum data transfer rate for the controller to use in communicating
with the device. For example, the transfer rate may need to be limited to
accommodate long cables between the controller and the device, such as with a tape
library. The transfer rate is negotiated immediately and does not require a restart in
order to take effect.
Example
This example shows how to add tape device TAPE20300 at port 2, target 3, LUN 0:
ADD PASSTHROUGH TAPE20300 2 3 0
ADD UNIT P100 TAPE20300
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
5–17