Table of Contents
Advertisement
5–70
CLI Commands
MIRROR
Creates a one-member mirrorset from a single disk. This command is used only on
disks configured as units or members of a stripeset. Enter the ADD MIRRORSET
command to create a mirrorset from disk drives not already members of higher level
containers.
After the disk drive is converted to a mirrorset, increase the nominal number of
members by entering the SET mirrorset-name MEMBERSHIP=number-of-members
command, then enter the SET mirrorset-name REPLACE=disk-name command to
add more members to the mirrorset.
NOTE: This command is also valid for a REMOTE disk, resulting in a single member
mirrorset with DT_SUPPORT enabled.
Syntax
MIRROR disk-name mirrorset-name
Parameters
disk-name
Specifies the name of the disk to convert to a one-member mirrorset. The disk must be
part of a unit.
mirrorset-name
Assigns a name for the mirrorset.
IMPORTANT: It is common to name a mirrorset MIRR n , where n is a sequentially
assigned, unique identifier. Other naming conventions are acceptable, but this
naming convention presents to the user both the type of container and its unique
identifier.
Advertisement
Chapters
Table of Contents
