Add Disk - Compaq StorageWorks HSZ80 Configuration And Cli Reference Manual

ADD DISK

Names a disk drive and adds it to the controller's configuration.
NOTE: The controller supports a maximum of 72 storage devices, even though
more than 72 target IDs are available. Do not exceed the maximum number of
devices in the subsystem.
Syntax
ADD DISK container-name scsi-port-target-lun
Parameters
container-name
Assigns a name to the disk device. This is the name used with the ADD UNIT
command to create a single-disk unit.
The disk name must start with a letter (A through Z) and may consist of a maximum
of nine characters including letters A through Z, numbers 0 through 9, periods (.),
dashes (-), or underscores (_).
IMPORTANT: It is common to name a disk drive DISK pttll , where pttll is the
disk's Port-Target-LUN address. Although other naming conventions are accept-
able, this one presents the user with the type of disk drive and its SCSI location.
scsi-port-target-lun
Indicates the SCSI device PTL address. Place one space between the port number,
target number, and the two-digit LUN number when entering the PTL address. See
the "Device PTL Addressing Convention within the Controller," page 3–36, for an
explanation of the PTL addressing naming format.
NOTE: See the HSZ80 Array Controller ACS Version 8.3 Release Notes to
determine whether the disk drive you are planning to use is compatible with the
controller.
Compaq HSZ80 Array Controller ACS Version 8.3 Configuration and CLI Reference Guide
5–7