Viewing And Editing Scsi Drives; Scanning New Scsi Drive - Compaq External RAID Controller & Subsystem Infortrend Operation Manual

Pass-through SCSI Commands are only intended to perform maintenance
functions for a drive or device on the drive side. Do not perform any
destructive commands to a disk drive (i.e., any commands that write data
to a drive media). If a disk drive is a spare drive or a member of a logical
drive, such a destructive command may cause a data inconsistency.
When a drive/device is mapped to a host SCSI ID so that Pass-through
SCSI Commands can be used, the data on that drive/device will not be
protected by the controller.
Commands to perform any write commands to drive media do so at their
own risk.
5.11

Viewing and Editing SCSI Drives

Scanning New SCSI Drive

Press ENT for two seconds to enter the
Main Menu. Press
"View and Edit SCSI Drives," then
press ENT.
SCSI
displayed on the LCD. Press ENT on a
drive. Use
SCSI Drive," then press ENT again.
Press
then press ENT for two seconds.
Press
press ENT for two seconds.
The information of the scanned SCSI
drive will be displayed on the LCD.
If the drive was not detected on the
selected SCSI channel and ID, the LCD
will display "Scan Fail!"
5-23
WARNING!
or
drive information
or to select "Scan New
or to select a SCSI channel,
or to select a SCSI ID, then
Users who employ Pass-through SCSI
View and Edit
to select
SCSI Drives
will be
Scan new SCSI
Drive
Scan Channel=1 ?
Scan Channel=1
ID= 01
C=1 I=0
NEW DRV
Scan Channel=1
ID=1 Scan Fail!
..
?
1010MB
SEAGATE
Infortrend