The Snmp_Trap Section; The Email Section; The Broadcast Section - Compaq External RAID Controller & Subsystem Infortrend Operation Manual

The SNMP_TRAP section

[SNMP_TRAP] – section header
[ENABLED] – 1=enabled, 0=disabled (applies to this section only)
[SEVERITY] - level of severity of the messages to be received:
1.
sends only the most serious events.)
[COMMUNITY] – SNMP community name of the destination/ receiver
[RECEIVER] – The IP address of the receiver computer. Add additional
lines to specify multiple receivers. Up to 4 receivers can be configured.

The EMAIL section

[EMAIL] – section header
[ENABLED] – 1=enabled, 0=disabled (applies to this section only)
[SEVERITY] - level of severity of the messages to be received:
notification, 2. warning, 3. alert. "1" covers events of all levels. "3" sends
only the most serious events.)
[SUBJECT] – add a topic to email. This can be used to specify the location
of the RAID system, if there are many.
[SENDER_MAIL_BOX] – a valid email address to be used as the "from"
part of the email message.
[SMTP_SERVER] – SMTP server used to send email. IP address only, do
not enter a host name here.
[RECEIVER#] – receiver's email address. The receiver's number followed
by an "=" mark, an email address, "comma," and the number to specify the
message severity level.
* * * *

The BROADCAST section

[BROADCAST] – section header
[ENABLED] – 1=enabled, 0=disabled (applies to this section only)
[SEVERITY] – level of severity of the messages to be received:
1. notification, 2. warning, 3. alert. "1" covers events of all levels. "3"
only the most serious events will be broadcast.)
[RECEIVER#] – The IP address of the receiver computer. Add additional
lines to specify multiple receivers. Up to 4 receivers can be configured.
3-10
notification, 2. warning, 3. alert. "1" covers events of all levels. "3"
Infortrend