Table of Contents
Advertisement
5.10
Viewing and Editing Host LUNs
Viewing and Deleting LUN Mappings
Press ENT for two seconds to enter the
Main Menu. Press
"View and Edit Host Luns", then press
ENT.
Press
press ENT to proceed.
Press
LUN number and its LUN mapping
information.
Press ENT on the LUN you wish to
delete.
Press ENT for two seconds to confirm
deletion. The deleted LUN has now
been unmapped.
For LUN Filtering functions, e.g., Create Host Filter Entry, Edit Host-
ID/WWN Name List, please refer to Chapter 8 "Fibre Operation."
Pass-through SCSI Commands
Pass-through SCSI commands facilitate functions like downloading
firmware for drives or devices (not controller firmware), setting
SCSI drive mode parameters, or monitoring a SAF-TE/S.E.S. device
directly from the host. To perform such a function, the SCSI device
must be mapped to a host SCSI ID.
From the Main Menu, press
select "View and Edit Host LUNs."
If you have primary and secondary
controllers, use the
controller for the device that you
would like to map.
Press
ID to "Physical Drive" or other device
and then press ENT.
Front Panel Operation
or
or
to select a host ID, then
or
to browse through the
or
to select the
or
to choose to map a SCSI
View and Edit
to select
Host Luns
CH=0 ID=002
Sec. Ctlr
CH=0 ID=0 LUN=0
Mapto LG0 PRT0
Delete CH0 ID0
LUN=00 Mapping ?
CH=0 ID=0 LUN=0
Not Mapped
or
to
View and Edit
Host Luns
Map Channel=0
ID=0 Pri Ctlr ?
Map to
Physical Drive ?
..
5-22
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the External RAID Controller & Subsystem Infortrend and is the answer not in the manual?