Viewing And Editing Scsi Drives; Scanning New Drive - Compaq External RAID Controller & Subsystem Infortrend Operation Manual

Pass-through SCSI Commands are only intended to perform maintenance
functions for a drive or device on the drive side. Do not perform any
destructive commands to a disk drive (i.e., any commands that write data
to a drive media). This will result in inconsistent parity among drives
included in a logical configuration of drives. If a disk drive is a spare drive
or a member of a logical drive, such a destructive command may cause a
data inconsistency.
When a drive/device is mapped to a host SCSI ID so that Pass-through
SCSI Commands can be used, the data on that drive/device will not be
protected by the controller.
Commands to perform any write commands to drive media do so at their
own risk.
7.11

Viewing and Editing SCSI Drives

Choose "View and Edit SCSI Drives" in the main menu. All drives
attached to the drive channels will be displayed on the screen.

Scanning New Drive

Terminal Operation
Users who employ Pass-through SCSI
7-22