Slot Number; Drive Entry; Identifying Drive; Deleting Spare Drive (Global / Local Spare Drive) - Compaq External RAID Controller & Subsystem Infortrend Operation Manual

If there is a drive connected after the array is started, choose a drive
and press [ENTER].
[ENTER].
Choose the drive channel and ID of the drive you wish to scan, then
press [ENTER].

Slot Number

Drive Entry

These two functions are reserved for Fault Bus configuration.

Identifying Drive

Move the cursor bar to the drive you wish to identify, then press
[ENTER].
drives" to flash the read/write LEDs of all the drives in the drive
channel. Choose Yes.
You may also choose "flash selected drive" or "flash all But
Selected drives" to flash the read/write LED of the selected drive
only, or all the drives except the selected drive. Choose Yes and
choose an extent of time from 1 to 999 seconds.

Deleting Spare Drive (Global / Local Spare Drive)

7-23
Choose "Scan SCSI drive", then press
The menu may vary according to the drive status.
Choose "Identify SCSI drive," then choose "flash all
Infortrend