Connect A Pc For The Configuration; Connection To The Nt - Auerswald COMpact 4410 USB Installation And Configuration Manual

Isdn pbx systems

Hide thumbs Also See for COMpact 4410 USB:

Operator's manual (76 pages)

Table Of Contents

Table of Contents

To be able to configure the PBX, you have to establish a connection

between your PC and the PBX and install the software on your PC.

Depending on the connection option of your PC, please observe the fol-

lowing advises:

Your PC is connected directly via USB port with the PBX

This requires a USB interface on the PC. The cable is enclosed.

Your PC is directly connected via serial port with the PBX

The cable is not enclosed.

Your PC is connected with the PBX via an ISDN PC-controller with

CAPI 2.0 driver software installed in your PC. This ISDN PC-con-

troller is connected on the internal ISDN bus.

Connection between PC and USB port of a system telephone COM-

fort 1200 or 2000 on the internal S

a USB interface on the PC.

You will get more information especially about the fixed wiring

of connections and about the minimum requirements of the

PC on

page

30.

Pic. 7: Connection:

USB Interface

Connect the western modular jack

enclosed ISDN cable to the NT (see

You will get more information especially about the connection

to a remote NT

page

1. Technical modifications in the layout may lead to a change in the position of the

ISDN jacks.