Problems Indicated By Messages; Warning Messages - MIMAKI UJV100-160 Operation Manual

5.2 Problems indicated by messages

If a problem occurs, the buzzer will sound, and a message will appear on the display. You can also use local
guidance when checking.
Take appropriate measures based on the message. If a message is displayed again even after you take the
recommended corrective action, contact your local dealer or our service office.

Warning messages

Message
MOTOR POWER OFF
Replace NCU Ink Pad
Replace NCU
NCU Sensor Lv Low
NCU Sens Adj Err H
NCU Sens Adj Err L
NCU CONNECT
Ink IC is not registered
Ink End
M _ _ _ _ _ _ _
Ink Near End
M _ _ _ _ _ _ _
Ink Error
COVER OPEN
Lower the clamp lever
Data Remain
Temporary Suspension
NO MEDIA
Please load media.
No media detected
"Displaying Machine Information (Local Guidance)"(P. 28)
Cause
• The motor stops due to some
action causing initialization—
for example, opening the
cover.
• The ink absorber needs to be
replaced.
• A problem was detected with
the nozzle clogging
assessment.
• The sensor's sensitivity is
impaired.
• Sensor sensitivity adjustment
failed.
• A problem was detected with
the NCU connection.
• The ink IC chip is not
registered.
• The registered remaining ink
level indicates the ink has
run out.
• The ink has run out.
• Ink levels are low.
• An ink error occurred.
• The cover is open.
• The clamp lever is raised.
• Print (RIP) data was
received.
• Printing has been paused.
• No media is loaded, or the
sensors are faulty.
• No media is loaded, or the
sensors are faulty.
• The media width has not
been detected.
121
Chapter 5 Dealing with Problems
Corrective action
• Wait until the initialization operation is
complete.
• The NCU ink absorber must be replaced.
Contact your local distributor, our sales
office, or service center.
• The NCU must be replaced. Contact your
local distributor, our sales office, or service
center.
• Clean the NCU. "NCU Cleaning"(P. 90)
• Replace the NCU if the error does not clear.
Contact your local distributor, our sales
office, or service center.
• Turn off the power on the machine and turn
it on after a while. "Turning Off the
Power"(P. 31)
• Replace with new ink.
Displayed"(P. 39)
• Replace with new ink.
Displayed"(P. 39)
• The ink will run out soon. Have new ink
ready.
• Check the ink error details.
(local guidance)"(P. 122)
• Close the cover.
• Lower the clamp lever.
• Switch to REMOTE mode and start printing
or clear the data and abort printing.
• Switch to REMOTE mode and resume
printing or clear the data and abort printing.
• Load media. "Loading the Media"(P. 53)
• Clean the media sensor.
Cleaning"(P. 95)
• Load media. "Loading the Media"(P. 53)
• Detect the media width.
Media"(P. 53)
"When Ink End is
"When Ink End is
"Ink errors
"Front"(P. 20)
5
"Media Sensor
"Loading the