Packing An Ex4200 Switch For Shipping - Juniper EX4200 Hardware Manual

Before you begin packing the switch or component:
Ensure that you have retrieved the original shipping carton and packing materials. Contact your JTAC
representative if you do not have these materials, to learn about approved packing materials. See
Customer Support to Obtain Return Material Authorization" on page
Ensure that you have the following parts and tools available:
Antistatic bag, one for each switch or component
Phillips (+) screwdriver, number 2

Packing an EX4200 Switch for Shipping

To pack a switch for shipping:
1. On the console or other management device connected to the switch (to the master switch in a Virtual
Chassis configuration), enter the CLI operational mode and issue the following command to shut down
the switch software:
user@switch> request system halt
Wait until a message appears on the console confirming that the operating system has halted.
2. Disconnect power from the switch by performing one of the following:
If the power source outlet has a power switch, set it to the OFF (0) position.
If the power source outlet does not have a power switch, gently pull out the male end of the power
cord connected to the power source outlet.
3. Remove the cables that connect the switch to all external devices. See
on page 215.
4. Remove all field-replaceable units (FRUs) from the switch.
5. If the switch is installed on a wall, rack, or cabinet, have one person support the weight of the switch
while another person unscrews and removes the mounting screws.
6. Remove the switch from the wall, rack, cabinet, or desk and place the switch in an antistatic bag.
7. Place the switch in the shipping carton.
8. Place the packing foam on top of and around the switch.
258.
"Disconnect a Fiber-Optic Cable"
260
"Contact