Mounting An Ex4200 Switch On A Wall - Juniper EX4200 Hardware Manual

Mounting an EX4200 Switch on a Wall

You can mount an EX4200 switch on a wall by using the separately orderable wall-mount kit.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
on page 58.
Read "General Safety Guidelines and Warnings" on page
Component Lifting Guidelines" on page
Remove the switch from the shipping carton (see
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
2 wall-mount brackets (provided with the wall-mount kit)
12 wall-mount bracket screws (provided with the wall-mount kit)
4 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not included)
Dust covers for ports (for EX4200-24F switches only; optional)
Hollow wall anchors capable of supporting the combined weight of two fully loaded switches, up to
44 lb (20 kg) (not included)—if you are mounting the switch in sheetrock (wall board with a gypsum
plaster core) or in wall board not backed by wall studs
WARNING:
with the front panel of the chassis pointing down in order to ensure proper airflow
and meet safety requirements in the event of a fire.
NOTE: For easier lifting, install any additional power supplies only after you mount the switch
on the wall.
To mount the switch on a wall:
271.
"Unpacking an EX4200 Switch" on page
When mounted in a vertical position, an EX4200 switch must be oriented
"Site Preparation Checklist for EX4200 Switches"
264, with particular attention to
124
"Chassis and
110).