Maintain Fiber-Optic Cables - Juniper EX4200 Hardware Manual

NOTE: If the switch does not detect the uplink module, see
Port Connectivity on an EX4200 Switch" on page
Figure 65: Installing an Uplink Module in an EX4200 Switch
NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade
of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
result in significant delays if you need replacement parts. This note does not apply if you replace
existing components with the same type of component.

Maintain Fiber-Optic Cables

IN THIS SECTION
Connect a Fiber-Optic Cable | 214
Disconnect a Fiber-Optic Cable | 215
How to Handle Fiber-Optic Cables | 215
"Troubleshooting Virtual Chassis
247.
. Failure to do so can
213