Replace A Member Switch With A Different Type Of Switch That Changes The Virtual Chassis To Mixed Mode - Juniper EX4200 Hardware Manual

user@switch# set member replaced-member-ID serial-number new-member-serial-number
NOTE: You can alternatively use the replace configuration editing command to substitute
the serial number of the replacement member switch for the replaced member's serial
number in the existing configuration item for the replaced member.
To configure the new member switch with a different member ID, associate the new switch's serial
number with the desired member ID and then delete the configuration item for the replaced member
switch, as follows:
[edit virtual-chassis]
user@switch# set member new-member-ID serial-number new-member-serial-number
user@switch# delete member replaced-member-ID
Replace a Member Switch With a Different Type of Switch That Changes the Virtual Chassis
to Mixed Mode
If you want to replace a member switch with a different type of switch that changes the Virtual Chassis
from a non-mixed to a mixed Virtual Chassis:
1. Remove the member switch as described in
Available for Reassignment to a Different Switch" on page
2. Use the configuration procedure for adding a new switch to an existing Virtual Chassis based on the type
of switch you are adding. (See the list of related documentation at the bottom of this page.)
See Understanding Mixed EX Series and QFX Series Virtual Chassis for the combinations of switches that
comprise a mixed Virtual Chassis.
SEE ALSO
Adding a New Switch to an Existing EX2300, EX3400, or EX4300 Virtual Chassis
Adding an EX4600 Switch to a Mixed or Non-mixed Virtual Chassis
Adding a New Switch to an Existing EX4650 or QFX Series Virtual Chassis
Adding a New EX4200 Switch to an Existing EX4200 Virtual Chassis (CLI Procedure) | 217
Adding an EX4200 Switch to a Preprovisioned EX4500 Virtual Chassis or a Preprovisioned Mixed EX4200
and EX4500 Virtual Chassis (CLI Procedure)
"Remove a Member Switch and Make Its Member ID
224.
229