Mounting An Ex4200 Switch - Juniper EX4200 Hardware Manual

"Mounting an EX4200 Switch on a Desk or Other Level Surface" on page 116
provided)
"Mounting an EX4200 Switch on a Wall" on page 124
5. Follow instructions in
6. Follow instructions for connecting power as appropriate for your site:
Connecting AC Power to an EX4200 Switch on page 134
Connecting DC Power to an EX4200 Switch on page 137
7. Perform initial configuration of the switch by following instructions in
EX Series Switch (CLI Procedure)" on page 153
(J-Web Procedure)" on page
8. Set the switch's management options by following the appropriate instructions:
Connect a Device to a Network for Out-of-Band Management on page 141
Connect a Device to a Management Console Using an RJ-45 Connector on page 142
SEE ALSO
Rack Requirements | 66
Cabinet Requirements | 67
Clearance Requirements for Airflow and Hardware Maintenance for EX4200 Switches | 69

Mounting an EX4200 Switch

You can mount the switch:
On two posts in a 19-in. rack or cabinet by using the mounting brackets provided with the switch.
On four posts in a 19-in. rack or cabinet by using the separately orderable four-post rack-mount kit.
In a position recessed 2 in. from the front of a 19-in. rack or cabinet by using the 2-in.-recess front
brackets in the separately orderable four-post rack-mount kit. You can mount the switch in this recessed
position on two-post or four-post racks and cabinets.
On a desk or other level surface by using rubber feet. The switch is shipped with four rubber feet to be
used to stabilize the chassis on a desk or other level surface.
On a wall by using the separately orderable wall-mount kit.
"Connect Earth Ground to an EX Series Switch" on page
156.
(using the separately orderable wall-mount kit)
"Connecting and Configuring an
or "Connecting and Configuring an EX Series Switch
(using the rubber feet
127.
115