Juniper EX4200 Hardware Manual page 232

To connect a Virtual Chassis cable to an EX4200 switch (see
1. Taking care not to touch module components, pins, leads, or solder connections, remove the Virtual
Chassis cable from its bag.
2. Using both hands, place the Virtual Chassis cable connector in the empty Virtual Chassis port and slide
it in gently until it is fully seated.
3. Slide the cable connector retainer over the Virtual Chassis cable connector.
4. Tighten the screws on the cable connector retainer by using the cross-head screwdriver.
Figure 68: Connecting a Virtual Chassis Cable to an EX4200 Switch
Slide cable connector retainer over
Virtual Chassis cable connector.
SEE ALSO
Planning EX4200, EX4500, and EX4550 Virtual Chassis | 103
Figure 68 on page 232):
232