Connect A Fiber-Optic Cable - Juniper EX4200 Hardware Manual

CAUTION:
fastened loops of cable to dangle, which stresses the cable at the fastening point.
CAUTION:
arc smaller than a few inches in diameter can damage the cable and cause problems
that are difficult to diagnose.
Figure 51: Install a Transceiver
1 Ejector lever
—

Connect a Fiber-Optic Cable

Before you connect a fiber-optic cable to an optical transceiver installed in a device, ensure that you have
taken the necessary precautions for safe handling of lasers (see
Warnings" on page 283).
To connect a fiber-optic cable to an optical transceiver installed in a device:
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
1. If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap. Save the cap.
2. Remove the rubber safety cap from the optical transceiver. Save the cap.
Do not let fiber-optic cable hang free from the connector. Do not allow
Avoid bending fiber-optic cable beyond its minimum bend radius. An
Do not look directly into a fiber-optic transceiver or into the ends of
"Laser and LED Safety Guidelines and
146