Register Products-Mandatory To Validate Slas; Installing And Connecting An Ex4200 Switch - Juniper EX4200 Hardware Manual

Register Products—Mandatory to Validate SLAs
Register all new Juniper Networks hardware products and changes to an existing installed product using
the Juniper Networks website to activate your hardware replacement service-level agreements (SLAs).
CAUTION:
update the installation base data if there is any addition or change to the installation
base or if the installation base is moved. Juniper Networks will not be held accountable
for not meeting the hardware replacement service-level agreement for products that
do not have registered serial numbers or accurate installation base data.
Register your product(s) at https://tools.juniper.net/svcreg/SRegSerialNum.jsp.
Update your installation base at
https://www.juniper.net/customers/csc/management/updateinstallbase.jsp.

Installing and Connecting an EX4200 Switch

The EX4200 switch chassis is a rigid sheet-metal structure that houses the hardware components.
To install and connect an EX4200 switch:
1. Follow instructions in
2. Install a power supply if it is not pre-installed; see
page 197.
3. Install a fan tray if it is not pre-installed; see
4. Mount the switch by following instructions appropriate for your site:
"Mounting an EX4200 Switch on Two Posts in a Rack or Cabinet" on page 117
brackets provided)
"Mounting an EX4200 Switch on Four Posts in a Rack or Cabinet" on page 120
orderable four-post rack-mount kit)
"Mounting an EX4200 Switch in a Recessed Position in a Rack or Cabinet" on page 123
2-in.-recess front brackets from the separately orderable four-post rack-mount kit)
Register product serial numbers on the Juniper Networks website and
"Unpacking an EX4200 Switch" on page
"Installing a Fan Tray in an EX4200 Switch" on page
110.
"Installing a Power Supply in an EX4200 Switch" on
194.
(using the mounting
(using the separately
(using the
114