Juniper EX4200 Hardware Manual page 125

1. Attach the wall-mount brackets to the sides of the chassis using four of the wall-mount bracket screws
on each side, as shown in
Figure 37: Attaching Wall-Mount Brackets to the Switch Chassis
1
2. If you are mounting two switches together, line the second switch on top of the first and attach it to
the mounting brackets using two wall-mount bracket screws on each side (see
3. Insert the mounting screws in the wall. Insert the top pair of mounting screws 474.35 mm apart, and
insert the second pair of mounting screws 151.81 mm directly below the first set.
If the mounting screws are inserted in wall board with no stud behind it, you must use dry wall anchors
rated to support 75 lb (34 kg). Insert the screws into wall studs wherever possible to provide added
support for the chassis.
Screw the screws only part way in, leaving about 1/4 in. (6 mm) distance between the head of the
screw and the wall.
4. Grasp each side of the switch or switches, lift the switch or switches, and hang the brackets from the
mounting screws as shown in
Figure 37 on page 125.
2
Figure 38 on page 126.
Figure 38 on page 126).
125