Connecting A Virtual Chassis Cable To An Ex4200 Switch - Juniper EX4200 Hardware Manual

Figure 67: Virtual Chassis Cable Connector in an EX4200 Switch
NOTE: If you order Virtual Chassis cables separately, you must reuse the cable connector
retainers provided with the original cable or order Virtual Chassis cable connector retainers also
separately.

Connecting a Virtual Chassis Cable to an EX4200 Switch

EX4200 switches have two Virtual Chassis ports on the rear panel. You can use the Virtual Chassis ports
to interconnect up to 10 EX4200 switches, enabling them to operate as a unified single high bandwidth
switch. To see illustrations of a few Virtual Chassis cabling configuration examples, see
Cabling Configuration Examples for EX4200 Switches" on page
Ensure that you have the following parts and tools available:
A cross-head screwdriver (provided in the uplink module kit)
NOTE: If you order Virtual Chassis cables separately, you must reuse the cable connector
retainers provided with the original cable or order Virtual Chassis cable connector retainers also
separately.
Virtual Chassis cable connector
Release pull tab
Cable connector retainer
"Virtual Chassis
105.
231