Sfp+ Uplink Module And Sfp+ Macsec Uplink Module - Juniper EX4200 Hardware Manual

35
Figure 6: SFP Uplink Module
SFP uplink modules are shipped with dust covers preinstalled in the ports.
The SFP uplink module requires Junos OS for EX Series switches, Release 9.0 or later.

SFP+ Uplink Module and SFP+ MACsec Uplink Module

The SFP+ uplink module and the SFP+ MACsec uplink module can be used for either SFP+ or SFP
transceivers. You configure the operating mode on the module to match the type of transceiver you want
to use—for SFP+ transceivers, you configure the 10-gigabit operating mode, and for SFP transceivers, you
configure the 1-gigabit operating mode. See Setting the Mode on an SFP+ or SFP+ MACSec Uplink Module .
By default, the SFP+ uplink module and the SFP+ MACsec uplink module operate in the 10-gigabit mode
and support only SFP+ transceivers. If you have not changed the module from the default setting and you
want to use SFP+ transceivers, you do not need to configure the operating mode.
If the operating mode and the configured mode for the uplink module are different, it is shown in the
output of show chassis pic fpc-slot slot number pic-slot 1.
Figure 7 on page 36 shows the SFP+ uplink module and the SFP+ MACsec uplink module.