Mounting An Ex4200 Switch On A Desk Or Other Level Surface - Juniper EX4200 Hardware Manual

The holes in the mounting brackets are placed at 1 U (1.75 in. or 4.45 cm.) apart so that the switch can be
mounted in any rack or cabinet that provides holes spaced at that distance.
See the Related Documentation for detailed descriptions of the various rack or cabinet mounting options.

Mounting an EX4200 Switch on a Desk or Other Level Surface

You can mount an EX4200 switch on a desk or other level surface by using the 4 rubber feet that are
shipped with the switch. The rubber feet stabilize the chassis.
Before mounting an EX4200 switch on a desk or other level surface:
Verify that the site meets the requirements described in
on page 58.
Place the desk in its permanent location, allowing adequate clearance for airflow and maintenance, and
secure it to the building structure.
Read "General Safety Guidelines and Warnings" on page
Component Lifting Guidelines" on page
Remove the switch from the shipping carton (see
Ensure that you have the following parts and tools available:
4 rubber feet to stabilize the chassis on the a desk or other level surface (provided in the accessory box
shipped with the switch)
Dust covers for ports (for EX4200-24F switches only; optional)
To mount the switch on a desk or other level surface:
1. Turn the chassis upside down on the desk or the level surface where you intend to mount the switch.
2. Attach the rubber feet to the bottom of the chassis, as shown in
3. Turn the chassis right side up on the desk or the level surface.
4. If it is an EX4200-24F switch, we recommend you insert dust covers in unused SFP ports.
"Site Preparation Checklist for EX4200 Switches"
264, with particular attention to
271.
"Unpacking an EX4200 Switch" on page
"Chassis and
Figure 30 on page 117.
116
110).