Juniper EX4200 Hardware Manual page 7

Chassis Viewer | 174
Maintaining Components
4
Maintaining the EX4200 Cooling System | 193
Removing a Fan Tray from an EX4200 Switch | 193
Installing a Fan Tray in an EX4200 Switch | 194
Maintaining the EX4200 Power System | 195
Removing a Power Supply from an EX4200 Switch | 195
Installing a Power Supply in an EX4200 Switch | 197
Maintain Transceivers | 199
Remove a Transceiver | 199
Remove a QSFP28 Transceiver | 202
Install a Transceiver | 204
Install a QSFP28 Transceiver | 206
Maintaining EX4200 Uplink Module | 208
Removing an Uplink Module from an EX4200 Switch | 208
Installing an Uplink Module in an EX4200 Switch | 211
Maintain Fiber-Optic Cables | 213
Connect a Fiber-Optic Cable | 214
Disconnect a Fiber-Optic Cable | 215
How to Handle Fiber-Optic Cables | 215
Replacing a Member Switch to Virtual Chassis | 216
Adding a New EX4200 Switch to an Existing EX4200 Virtual Chassis (CLI Procedure) | 217
Adding a New Switch to an Existing Virtual Chassis Within the Same Wiring Closet | 217
Adding a New Switch from a Different Wiring Closet to an Existing Virtual Chassis | 219
Adding a New Switch to an Existing Preprovisioned Virtual Chassis Using Autoprovisioning
Removing or Replacing a Member Switch of a Virtual Chassis Configuration | 223
Remove a Member Switch and Make Its Member ID Available for Reassignment to a
Remove, Repair, and Reinstall the Same Switch | 225
Remove a Member Switch, Replace It with a Different Switch, and Reapply the Old
and Automatic VCP Conversion | 221
Different Switch | 224
Configuration | 226
vii