Maintaining Virtual Chassis Cable; Disconnecting A Virtual Chassis Cable From An Ex4200 Switch - Juniper EX4200 Hardware Manual

Adding an EX4500 Switch to a Preprovisioned EX4200 Virtual Chassis (CLI Procedure)
Adding an EX4500 Switch to a Nonprovisioned EX4200 Virtual Chassis (CLI Procedure)
Adding or Replacing a Member Switch or an External Routing Engine in an EX8200 Virtual Chassis (CLI
Procedure)
Monitoring the Virtual Chassis Status and Statistics on EX Series Virtual Chassis
Setting an Uplink Port on an EX Series or QFX Series Switch as a Virtual Chassis Port

Maintaining Virtual Chassis Cable

IN THIS SECTION

Disconnecting a Virtual Chassis Cable from an EX4200 Switch | 230

Connecting a Virtual Chassis Cable to an EX4200 Switch | 231
Disconnecting a Virtual Chassis Cable from an EX4200 Switch
If you need to disconnect an EX4200 switch from a Virtual Chassis configuration, you need to disconnect
the Virtual Chassis cable from the Virtual Chassis ports (VCPs).
Ensure that you have the following parts and tools available:
A cross-head screwdriver (provided in the uplink module kit)
To disconnect a Virtual Chassis cable from an EX4200 switch (see
1. Loosen the screws on the cable connector retainer by using the cross-head screwdriver.
2. Slide the cable connector retainer back.
3. Gently pull the release pull tab on the Virtual Chassis cable connector to release the lock holding the
Virtual Chassis cable connector in the Virtual Chassis port.
4. Gently pull the Virtual Chassis cable connector out of the Virtual Chassis port.
Figure 67 on page 231):
230