Connecting The Ex4200 To The Network; Install A Transceiver - Juniper EX4200 Hardware Manual

143
2. Connect the other end of the Ethernet cable to the console server (see Figure 49 on page 143) or
management console (see Figure 50 on page 143).
Figure 49: Connect a Device to a Management Console Through a Console Server
PC
To Console Port Console Server
Figure 50: Connect a Device Directly to a Management Console
To Console port PC

Connecting the EX4200 to the Network

IN THIS SECTION

Install a Transceiver | 143

Connect a Fiber-Optic Cable | 146
Install a Transceiver
The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs): You can remove and replace them without powering off the device or disrupting the device
functions.