Juniper EX4200 Hardware Manual page 158

Hide thumbs Also See for EX4200:
Table of Contents

Advertisement

To connect and configure the switch by using the J-Web interface:
1. Transition the switch into initial setup mode:
EX2200 and EX2200-C switch—Press the mode button located on the lower right corner of the front
panel for 10 seconds.
EX3200, EX3300, EX4200, EX4300 switches except EX4300-48MP and EX4300-48MP-S switches,
EX4500, EX4550, EX6200, or EX8200 switch—Use the Menu and Enter buttons located to the right
of the LCD panel (see
Figure 53: LCD Panel in an EX3200, EX4200, EX4500, EX4550, or EX8200 Switch
Figure 54: LCD Panel in an EX4300 Switches Except EX4300-48MP and EX4300-48MP-S Switches
1
LCD panel
2
LCD panel Enter button
1. Press the Menu button until you see MAINTENANCE MENU. Then press the Enter button.
2. Press Menu until you see ENTER EZSetup. Then press Enter.
If EZSetup does not appear as an option in the menu, select Factory Default to return the switch
to the factory default configuration. EZSetup is displayed in the menu of standalone switches
only when a switch is set to the factory default configuration.
3. Press Enter to confirm setup and continue with EZSetup.
2. Connect the Ethernet cable from the Ethernet port on the PC to the switch.
EX2200, EX3200, or EX4200 switch—Connect the cable to port 0 (ge-0/0/0) on the front panel of
the switch.
EX3300 switch—Connect the cable to the port labeled MGMT on the rear panel of the switch.
EX4300 switches except EX4300-48MP and EX4300-48MP-S switches—Connect the cable to the
port labeled MGMT on the rear panel of the switch.
Figure 53 on page 158
or
Figure 54 on page
158):
3
LCD panel Menu button
4
Chassis status LEDs
158

Advertisement

Table of Contents
loading

Table of Contents