Configure The Imagescalingmode Settings - JAI SW-4010Q-MCL-M52 User Manual

SW-4010Q-MCL-M52 User Manual (Tentative)

Configure the ImageScalingMode Settings

Notes:
The SWIR channel does not support the ImageScalingMode function.
l
For more information on this function, see
l
1. To check the ImageScalingMode setting, enter the command ISM?<CR><LF> from the
terminal emulator software. The default setting is Off (ISM=0).
2. Enter ISM=1<CR><LF> to enable ImageScalingMode.
3. Configure other ImageScalingMode settings as required.
For more information, see the following Short ASCII command table.
Item
ImageScalingMode
ImageScalingSumMode
ImageScalingHorizontalRaw ISH
ImageScalingWidthMax
Short ASCII
Command
0: Off (Default)
1: On
ISM
2: SWIRPixelMode
3: SWIRHalfPixelMode
0: Off (Average) (Default)
ISSM
1: On (Sum)
256 ~ 4096 (Default), Step 2
Min, Step: 16
Default: 4096
Max:
ImageScalingMode=Off: 4096
ImageScalingMode=On:((4096 x
ISWMAX
ImageScalingHorizontal*) / 16) x 16
ImageScalingMode=SWIRPixelMode: 1024
ImageScalingMode=SWIRHalfPixelMode: 2048
Note: *ImageScalingHorizontal =
ImageScalingHorizontalRaw /4096
Image Scaling Mode
Values
- 25 -
Preparation
(Xscale).
Command
Examples
ISM=[Param.]<CR><LF>
ISM?<CR><LF>
ISSM=[Param.]<CR><LF>
ISSM?<CR><LF>
ISH=[Param.]<CR><LF>
ISH?<CR><LF>
ISWMAX=
[Param.]<CR><LF>
ISWMAX?<CR><LF>