JAI SW-4010Q-MCL-M52 User Manual page 30

SW-4010Q-MCL-M52 User Manual (Tentative)
For more information, see the following Short ASCII command table.
Item
PixelBlack
CorrectionMode
PerformPixelBlackCalibration PBR
PixelBlackDetectResult
SWIR
1. Select User to save the black level correction value with SWIRPixelBlackCorrect.
Note: You cannot perform calibration when Off or Factory is selected.
2. Black level correction data is automatically generated by SWIRPixelBlackCalibration and
saved in the user area specified in step 1.
3. You can check the execution result of black level correction by
SWIRPixelBlackCalibrationResult.
For more information, see the following Short ASCII command table.
Item
SWIRPixelBlackCorrect
SWIRPixelBlackCalibration IRPBR
SWIRPixelBlackCalibration
Result
Short ASCII
Values
Command
0:Off
1:Default (Default)
PBC 2:User1
3:User2
4:User3
1: Succeeded
2: Image too bright
PBS
3: Image too dark
4: Timeout error
Short ASCII
Command
0:Off (Default)
IRPBC 1:Factory
2:User
0: Pixel black correction has not been finished
yet.
1: Succeeded.
IRPBS
2: Error1 –Image was too bright.
3: Error2 –Image was too dark.
4: Error3 –Timeout occurred.
Command Examples
PBC=[Param.]<CR><LF>
PBC?<CR><LF>
Note: Default stores correction data with factory settings.
- PBR<CR><LF>
PBS?<CR><LF>
Values
-
- 30 -
Preparation
Command Examples
IRPBC=[Param.]<CR><LF>
IRPBC?<CR><LF>
Note: Factory stores correction
data with factory settings.
IRPBR<CR><LF>
IRPBS?<CR><LF>