Step 3: Verify The Connection Between The Camera And Pc - JAI SW-4010Q-MCL-M52 User Manual

SW-4010Q-MCL-M52 User Manual (Tentative)

Step 3: Verify the Connection Between the Camera and PC

Use a short ASCII command to verify whether the camera is properly recognized in your setup.
1. Install terminal emulator software capable of serial communication to the PC connected to
the camera via the frame grabber board.
Set the following serial communication.
Baud Rate: 9600
l
Data Length: 8bit
l
Start Bit: 1bit
l
Stop Bit: 1 bit
l
Parity: None
l
Xon/Xoff Control: None
l
2. Enter the command DVN? <CR><LF> from the terminal emulator software.
If correctly connected, response DVN = JAI Corporation will be displayed.
Item
DeviceVendorName DVN
Short ASCII Command
- 23 -
Description
DVN? <CR><LF>
Display the device vendor name: "JAI Corporation"
Preparation