JAI SW-4010Q-MCL-M52 User Manual page 101

SW-4010Q-MCL-M52 User Manual (Tentative)
Item
Variable Line Rate
Electronic shutter
Test Pattern
Synchronization
Image Processing
Operation Mode
Trigger Inputs
Synchronous output (when
the terminal is open)
Communication interface
Field Update
RGB
Variable Range: Width = 4096
RGB8: 500 ~ 20.5kHz
RGB10/12: 500 ~ 13.7kHz
Variable Range: Width = 4096
RGB8: 500 ~ 40.8kHz
RGB10/12: 500 ~ 27.3kHz
Variable Unit: 0.1Hz
Supported Mode:
Exposure Mode = OFF / TriggerMode = Off
ExposureMode = Timed / TriggerMode = Off
Supported (Exposure Mode: Timed)
Variable Range: 3 ~ 15149.07 us
Variable Unit: 0.01 us
Note: Exposure Offset Duration: -0.85 μs
White, GreyPattern1(Ramp), GreyPattern2
(Stripe), ColorBar
1. Pixel sensitivity correction: Pixel correction
(DSNU, PRNU)
2.Shading correction: ColorShading, FlatShading
3. LUT: OFF: γ = 1.0, ON: 257 points can be set
4. Gamma: 0.45, 0.5, 0.55, 0.6, 0.65, 0.75, 0.8,
0.9, 1.0 (9 steps available)
5. Noise reduction: MEDIAN, FLIR,
NoiseReduction
Exposure Mode : Off (Internal/External trigger)
Exposure Mode : Timed (Internal/External
trigger)
TTL Input (12-pin and 10-pin)
Camera Link: LVDS (CC1)
Positive / negative logic switchable.
Minimum trigger width: CameraLink 3μs / TTL In 50ns
Camera Link: LVAL (Camera Link Tx24, DVAL (Camera LinkTx25), ExposureActive (Camera Link
Tx26)
12-pin: Exposure Active or LVAL
10-pin: Exposure Activeor LVAL
EIA-644: Camera Link (SerTFG, SerTC)
Communication Rate: 9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps, 230400 bps,
460800 bps, 921600 bps
Supported
Variable Range: 500 Hz ~ 39.2kHz
Variable Unit: 149.9 ns
Supported Mode:
Exposure Mode = OFF / TriggerMode = Off
ExposureMode = Timed / TriggerMode = Off
Supported
Variable Range: 20.38us (1L) ~ 1994.85 us
Variable Unit: 149.9 ns
Note: No exposure offset duration.
GreyHorizontalRamp, GreyScale2, White
Internal
1. Pixel sensitivity correction: Pixel correction
(DSNU, PRNU)
2. Defective pixel correction: Up to 16 pix
3. Shading correction: FlatShading
4. LUT/Gamma function: 1.00 (OFF) / 0.45 / User
(LUT) selectable. When set to User, table data
can be applied from externally. Table data can be
configured individually.
5.Lens aberration correction ±3 pix
6. Noise reduction: Individual ON/OFF switching
possible
Exposure Mode : Off (Internal/External trigger)
Exposure Mode : Timed (Internal/External trigger)
PWC (External trigger)
- 101 -
Miscellaneous
SWIR