Table of Contents
Advertisement
GO-2400MC-PGE | GO-2401MC-PGE | User Manual (Ver. 3.0)
Configure Exposure and External Trigger Settings
Configure settings related to exposure control methods and trigger control. The factory settings are as
follows. Change settings as necessary, according to the intended purpose or application.
Factory Default Values
Item
Trigger Selector
- Trigger Mode
- Trigger Source
- Trigger Activation
Exposure Mode
Exposure Time
Exposure Auto *
Note: *This item is only enabled when Exposure Mode is set to Timed.
Cautions:
When Exposure Mode is set to Off, Trigger Mode cannot be set to On. Other settings may
l
also be restricted depending on the exposure mode, so be sure to set the exposure mode
before configuring the trigger settings.
Adjusting Packet Size: With Trigger Mode set to Off and Exposure Mode set to
l
Continuous, clicking the Start Acquisition button should produce a live image. If, however,
you can only see a black screen, it may be the result of the packet size setting in the camera
being larger than the packet size setting in the GigE NIC or switch. To correct the problem,
you can either reduce the Packet Size setting to a value less than 1500 in the eBUS Player
for JAI (under Transport Layer Control / Stream Channel Selector, or set your NIC or switch
to support "Jumbo Frames." This setting is typically found in the Advanced Adapter Settings
for the NIC or switch which can be accessed through the Device Manager on your PC.
Frame Start
Off
Line 5 - Optical In 1
Rising Edge
Timed
GO-2400MC-PGE: 18000 (μs)
GO-2401MC-PGE: 24087 (μs)
Off
- 29 -
Default
Preparation
Advertisement
Table of Contents
