SW-4010Q-MCL-M52 User Manual (Tentative)
Load the User Settings
1. Stop image acquisition. User settings can only be loaded when image capture on the
camera is stopped.
2. Specify the storage location (UserSet1 - UserSet3) using the UserSetLoad command and
read the settings of the camera.
Note: When selecting Default for UserSetSelector, the factory settings are loaded.
For more information, see the following Short ASCII command table.
Item
UserSetLoad
Short ASCII
Values
Command
0:Default (Default)
1:User1
LD
2:User2
3:User3
Command Examples
LD=[Param.]<CR><LF>
LD?<CR><LF>
- 36 -
Preparation