Acquisitioncontrol - JAI SW-4010Q-MCL-M52 User Manual

SW-4010Q-MCL-M52 User Manual (Tentative)

AcquisitionControl

Configure image capture settings for the RGB channels.
Acquisition Control Item Setting Range Default Value
AcquisitionLineRate (Hz)
Related Topic:
Variable Line Rate
TriggerMode
Related Topic: Trigger
Control
TriggerSource
TriggerActivation
ExposureMode
Related Topic:
Exposure Mode
ExposureTimeMode
- 500
0:Off
0:Off
1:On
20: Line4 TTL
-
In1
1:Falling Edge
0:Rising Edge
(falling edge of
1:Falling Edge
input signal)
0: Off
1: Timed
1: Timed
0: Common
0: Common
1: Individual
Set the AcquisitionLineRate(Hz).
Min: 500
Max:
- Width = 4096: (RGB8) 20.5kHz, (RGB10/12) 13.7kHz
- Width = 2048: (RGB8) 40.8kHz, (RGB10/12) 27.3kHz
Step: 0.1
Select the trigger mode. When ExposureMode is set to
TriggerWidth, TriggerMode is automatically set to On.
Select the trigger signal source.
0: Low
1: High
10-13: PulseGenerator0-3
14-17: UserOutput0-3
20: Line4 TTL In1
21: Line5 Opt In1
23: Line7 CC1
24: Line10 TTL In2
26: NAND0 Out
27: NAND1 Out
28: Line13 TTL In3
29: EncoderTrigger
Select the polarity of the trigger signal (i.e., location of signal at
which trigger is applied).
Select the exposure mode.
Select the Exposure setting method.
Select Common to set a common value for all three sensors.
Select Individual to set the value for each channel.
Note: This item is available only when ExposureMode is
set to Timed.
- 74 -
Setting List
Description