Step 5: Adjust The Image Quality; Configure The Line Rate; Dsnu Correction (Pixel Black Correct) - JAI SW-4010Q-MCL-M52 User Manual

Rgb color & swir prism line scan camera with mini camera link interface

Table of Contents

SW-4010Q-MCL-M52 User Manual (Tentative)

Step 5: Adjust the Image Quality

Related Setting Items:

To maximize the performance of the camera, configure its basic function in the following order.

Note: On this camera, you must configure both the RGB and SWIR channels individually.

You can set the line rate to 1L or more.

This function can be used to match the scanning speed of the camera to the feeding speed of the

object or to lengthen the accumulation time to increase sensitivity.

Note: Refer to the

DSNU (dark signal non-uniformity) is a variation between pixels in the dark areas generated by

the sensor. If the line rate is slowed or a long exposure time is set, the dark current in the sensor

may change and the state of the DSNU may change.

RGB

1. Specify the user area (User1 ~ User3) to save the black level correction value with

PixelBlackCorrectionMode.

Note: You cannot perform calibration when Off or Default is selected.

2. Black level correction data is automatically generated by PerformPixelBlackCalibration

and saved in the user area specified in step 1.

3. You can check the execution result of black level correction by PixelBlackDetectResult.

AnalogControl

Control via External Triggers

and

Control Without External Triggers

- 29 -

Preparation

topics.

Table of Contents