JAI SW-4010Q-MCL-M52 User Manual page 88

SW-4010Q-MCL-M52 User Manual (Tentative)
Pulse Generator Item
PulseGeneratorEndPointMs
(ms)
PulseGeneratorPulseWidth
(ms)
PulseGeneratorRepeat
Count
PulseGeneratorClear
Activation
PulseGeneratorClear
Source
PulseGeneratorClearInverter
PulseGeneratorClear
SyncMode
Setting Range Default Value
- 0.15
- 0.15
0 ~ 255 0
0: Off
1: Level High
2: Level Low 0: Off
4: Rising Edge
8: Falling Edge
- 0: Low
0:False
0:False
1:True
0:Async Mode
0:Async Mode
1:Sync Mode
Set the start point of the Low interval in milliseconds.
When the counter reaches this value, the output will
be 0. The setting range varies depending on the
ClockPreScaler value.
PulseGeneratorEndPoint = 1/PulseGeneratorClock *
PulseGeneratorEndPoint
Display the High interval width of the pulse in
milliseconds. The duration between the Start Point
and End Point is calculated. The setting range varies
depending on the ClockPreScaler value.
PulseGeneratorPulseWidth = 1/PulseGeneratorClock
* (PulseGeneratorEndPoint -
PulseGeneratorStartPoint)
Set the repeat count for the counter. When this is set
to 0, a free counter is enabled with no repeat limit.
Set the clear signal condition for the count clear input
of the pulse generator.
Select the count clear input signal source.
0: Low
1: High
7: ExposureActive
9: LVAL
10-13: PulseGenerator0-3
14-17: UserOutput0-3
20: Line4: TTL In1
21: Line5: Opt In1
23: Line7 - CC1
24: Line10: TTL In2
26: NAND0 Out
27: NAND1 Out
28: Line13: TTL In3
29: EncoderTriger
30: EncoderDirection
31: SWIRExposureActive
32: SWIRLVAL
Note: (※)Disabled if the PulseGenerator is selected in
PUlseGeneratorSelector.
Controls if the pulse generator clear signal is inverted.
False means "Active High" and True for "Active Low".
Select the sync mode for the count clear input signal.
- 88 -
Setting List
Description